![]() ![]() How do I proceed from here? I guess the float itself can be bad or the float needle is not sealing properly? Also, the carb has been sitting for almost 1 year, could it have getting stuck so maybe I should fill it up again and do another try? Well, the test indicated quite good level in 3 bowls (-1 mm, -2 mm and -3 mm below bowl edge) but one sat at +10 mm! I drained the carb and checked the static height measurement which showed 18,9 mm (18,6 is stated in manual), as I understand, a bigger measurement will give a lower level here so if anything, this bowl would be low? ![]() 2 years ago I cleaned the carb good and put in new keyster kits. Im getting close to firing up my bike for the first time after some restoration work (project thread), and did the clear tube check yesterday on the carb.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |